Using a set of rubber mount Sporty controls to start,
I cut the mount ends off to get.....
This piece as the base for the new mid controls.
I then drilled a 5/8 hole in the middle of the new base piece
which I welded some 5/8 round stock into
Then cut the same piece off of the other Sporty control, and tapped the holes to 3/8-16. Cleaned the paint off and bolted the two together.
Welded the whole assembly to the frame where I wanted the controls
and got to heating and.....
bending to the desired hieght.
THE RESULT mid controls.